Alfa Romeo/Alfa Romeo Digest Archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[alfa] Is this transmission toast?



This past Sunday I drove my '73 spider to a bike race 190 miles away. I got a late start and had to drive fast (got there in 2.5 hours) and with two bikes on the trunk and the top town, it was pretty noisy on the interstate at 80. This drive was early, at 7am and the temperatures were cool and the car ran fine. But in the heat of late afternoon on the return trip the car began to make an unholy sound from the transmission - the sound of a screeching bearing going bad. I nursed the car back home, with the trans having the bearing screech come and go as I drove the on the interstate and adjusting speed to eliminate or minimize the transmission sound. At times smoke would emit from the shift boot, and if the screech got real bad (it came and went with varying degrees of severity), I could feel the car slow as if I had pulled on the emergency brake.

But I made the 190 miles home. The trans felt hot, but nothing I could really point to as abnormal and it didn't stink of hot burned oil. Tonight I drained the trans oil and only got about a half quart to come out. I did not see any obvious amount of metal in the oil. The magnetic drain plug did not have an unusual amount of metal on it, but I stuck my finger into the drain and wiped it around (it felt "gritty"), and when I wiped off there was obviously metal flakes from this bottom sludge. Unfortunately, I was unable to drain the trans when it was hot, so I'm not sure if metal residue just settled in the bottom of the trans rather than draining out with the oil.

SO it appears that I drove the car too far and too long and too hard with too little transmission oil, and a bearing has gone bad. What to do?

My initial thought is to refill the transmission with 30 or 40 (or?) weight oil and do a little test driving to ascertain (a) if the proper amount of oil will eliminate the bearing noise and (b) if this thin oil will wash out the metal residue from the transmission. If the noise is eliminated, I'll drain the thin oil and replace with proper gear lube and just drive it.

Or is this just wishful thinking, and the transmission has been ruined, and I might as well just replace or rebuild it?

Opinions or experiences with such situations?

thanks, //kct, Powell, TN
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided



Home | Archive | Main Index | Thread Index