RE: [ihc] Travelall 1010 parts wish list

["John M. Adams" <jma@xxxxxxxxxxx>]

I don't know if it would fit your truck, but I have the 3rd/rear/shorter
seat from a '64 T'All that I don't want. It's in pretty good shape.

On cleaning cowls, the only way in (again, on an older rig - a '67) is
either down and to the side through the vent in front of the windshield,
or up, through, and over the vent tubes from inside. The heater has to
come out on the right, and the vent flap on the left. I'm thinking of
cutting access panels on mine, under the hood near the hinges. If I can
figure a way to make it look decent, and not weaken the hinge mounts,
I'll cut two holes just large enough to get my hand in.

Sorry if this is inapplicable to your 1010. I'm not familiar with the
"newer" (post '68) trucks.

-John A.

-----Original Message-----
From: owner-ihc@domain.elided [mailto:owner-ihc@domain.elided]On Behalf Of Mac
@ TRIAD
Sent: Monday, November 24, 2003 6:07 AM
To: DeepSouthScouts@domain.elided; ihc-digest@domain.elided
Subject: RE: [ihc] Travelall 1010 parts wish list


>> 3rd seat mount and/or seat

>> Can the floor/footwell fresh air vents be removed to clean/vacuum out
>> the lower cowl area (where all the leaves settle) like on the Scout II?
>> If not, then am I right in figuring that the front fenders have to come
>> off, or is there another way to clean out the cowl vent area?


---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.542 / Virus Database: 336 - Release Date: 11/18/03