Re: E30 Reverse Light Switch

[Im4BMW@xxxxxxx]

Fernando,

In a message dated 7/6/00 6:08:51 AM Eastern Daylight Time, 
owner-bmw-digest@domain.elided writes:

<< I purchased a new switch from the dealer and when I tried to
 replace it, I could see no way to do it other than dropping the
 transmission. 
 My question is: a) is there a trick to replace the switch? or b) is there
 a special tool that will fit the tight space?
 Suggestions are welcomed. >>

YES, it can be done...no tricks however.  It is indeed tight in there, but 
you shouldn't have to lower the engine to do the replacement.  Try a stubby 
wrench...check the mm size on the new switch beforehand to ensure proper 
wrench size.  As a last resort you could lower the tranny slightly, but what 
a pain if not necessary.  I know what you are going through, as I recently 
did the switch replacement on my son's '87 325is...took me about 5minutes (or 
less).

Good luck,

and BTW, what does "P.Eng." stand for?

John Weese, P.E. (Professional Engineer)
Landisville, PA (USA)

------------------------------