RE: Spider Chassis Stiffener

["Brian Shorey" <bshorey@xxxxxxxxx>]

> First of all there is a flaw in the instructions. They tell you to
start at
> the front then go to the back and install the big bolts that go
through the
> trailing arms. This is exceedingly difficult to do. If you put the
rear
> trailing arm bolts in first it is very easy to use an appropriately
sized
> round pry bar in one of the mounting holes in the forward plate and
frame
> member to align it so that you can get the other two bolts in and
started.
> There's plenty of room and you will have ample leverage to make this a
very
> easy task.

Good advice.

It should also be mentioned, in case it's not obvious, but don't tighten
any of the hardware until all of it has been put in place.  Makes it
easier to move things around during installation.

bs
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided