Re: [ihc] 12" clutch problems in Scout II AGAIN!

["Joseph Shaw, II" <josephshaw@xxxxxxxxxxxxx>]

Joel-

I will only say that one thing that does seem to be different about a lot of
IH's is the TO bearing.  I always thought IH used about the same thing for
everything, but found out the hard way, when changing the clutch in a '74,
that they do make a few different TO bearings, and use them differently in
similar applications.  My guess is the one you installed is the wrong one
for the clutch/tranny you have used.

Maybe not, and you likely already know this, but it took me quite a while to
figure mine out-they didn't seem that different, but the groove for the
"fingers" was located differently.

Good luck!

Michael

----- Original Message -----
From: "Joel M Brodsky" <jmbrodsky@domain.elided>
To: <ihc@domain.elided>
Sent: Monday, October 27, 2003 7:23 AM
Subject: [ihc] 12" clutch problems in Scout II AGAIN!


      After installing the 12" clutch with the greasable throwout sleeve
> (all the zerk-equipped sleeves I've seen have been end-drilled to grease
> the throwout brg.) I noticed that the three clutch actuating fingers were
> significantly depressed.  Well, that didn't bother me much, I didn't think
> much of it.  Then I put the throwout collar on and put the rig back
> together.
>


> entirely in the fact that the three clutch actuating fingers are way down
> in there when the clutch is all mounted up.
>
> Thanks!
>
> JoelB
> Scouts, TAs, and a Bolbo.