RE: Balancing Flywheels for 345/392

To: "IH Digest" <ihc-digest@domain.elided>
Subject: RE: Balancing Flywheels for 345/392
From: "Kurt Musgrave" <rvar@domain.elided>
Date: Sat, 24 Apr 1999 16:20:46 -0600
Content-Transfer-Encoding: 7bit
Content-Type: text/plain;charset="iso-8859-1"
Importance: Normal
In-reply-to: <v01510101b347dcd600fc@[204.132.128.2]>
Reply-To: "Kurt Musgrave" <rvar@domain.elided>
Sender: owner-ihc@domain.elided

From the MT-124 parts manual:  1000D thru 1500D

Crank pulley is the same  304-345-392,  369 721 C1;  266 is different,  227
709 R1; but I think only because in the listing in this book the 266 is two
piece, 304,345,392 is one piece.

Flywheel  266-304; 151 117 R21
	   345-392; 151 115 R31
Is this only because they are drilled for different clutches?

Crankshaft is different for each engine  266, 242 877 R92; 304, 242 878 R92;
345, 242 879 R92; 392, 874 884 R91.  These are part numbers for standard
size with bearings.

Kurt

References:
- Re: Balancing Flywheels for 345/392
  - From: bearbvd@domain.elided (Greg Hermann)

Prev by Date: Re: Cost of gas & mileage
Next by Date: RE: My new Travelall - taking stock
Prev by thread: Re: Balancing Flywheels for 345/392
Next by thread: RE: Balancing Flywheels for 345/392
Index(es):
- Date
- Thread

Home | Archive | Main Index | Thread Index