IHC/IHC Digest Archive

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: CV Joints

To: "Allan & Kathryn Weidenheimer" <allanw@domain.elided>, <ihc@domain.elided>
Subject: Re: CV Joints
From: "Rik DesJardin" <rik@domain.elided>
Date: Sat, 24 Apr 1999 12:06:30 -0700
References: <199904241400.HAA27231@domain.elided>
Reply-To: "Rik DesJardin" <rik@domain.elided>
Sender: owner-ihc@domain.elided

Allan Excellent!!
.
 Especially since you have 1210; which the running gear came off of.  Stock
front Scout drive lines are pretty small diameter compared to 1210's also
My secret is to cut the driveshaft tube with a lathe.  Cut the yoke off then
cut the shaft to length, then slip the yoke back into the shaft, line it up,
and weld.
Rik

References:
- Re: CV Joints
  - From: "Allan & Kathryn Weidenheimer" <allanw@domain.elided>

Prev by Date: Re: SUPER GLUE
Next by Date: Re: Balancing Flywheels for 345/392
Prev by thread: Re: CV Joints
Next by thread: Re: CV Joints
Index(es):
- Date
- Thread

Home | Archive | Main Index | Thread Index