Re: shaking, heater, jack

[Steve Stegmann <stegmann@domain.elided>]

On Fri, 16 Apr 1999, Daniel Nees wrote:

> The rear shaft is a piece of cake. Just block the wheels, put the
> transfer case or tranny in nuetral and crawl under with a half inch
> wrench. There are 4 u-bolts that clamp the joints to the pinion yokes.
> Just unbolt them and pull the clamps off and Voila! one driveshaft in
> hand.
> 
Dan,

You should have mentioned that you should mark the driveshaft so you get
the pieces back in the same orientation.  Else you can get vibration from
an out-of-phase U-joint.

Steve