Re: E30 Sloppy Shifter

[Norman Boehl <nboehl@xxxxxxxxxxxxxxxx>]

Jay Snyder wrote:

> On Fri, 11 Sep 1998, Norman Boehl wrote:
>
> > It sounds like you are telling me that the output flange has three "studs"
> > that protrude through the flex disk, balancer, and then through the driveshaft
> > flange, and finally held in place with nuts.  I was under the impression that
> > these were bolts that needed a wrench on the tranny side to hold them from
> > turning while I remove the nuts.  Is this true?  If so, that makes life a lot
> > easier.  If not, how do I get a wrench on the heads of the bolt?
>
> Yes, there are studs on the output flange.  On the later ones w/o the
> balancer, there are bolts, but you can get to them with the crossmember.
>

Mucho Mucho thanks !!
Norm

- --
***  Remove "nospam-" from address when responding via email  ***

------------------------------