Re: E30 Sloppy Shifter

[Jay Snyder <jsnyder@xxxxxxxxxxxxxx>]

On Fri, 11 Sep 1998, Norman Boehl wrote:

> It sounds like you are telling me that the output flange has three "studs"
> that protrude through the flex disk, balancer, and then through the driveshaft
> flange, and finally held in place with nuts.  I was under the impression that
> these were bolts that needed a wrench on the tranny side to hold them from
> turning while I remove the nuts.  Is this true?  If so, that makes life a lot
> easier.  If not, how do I get a wrench on the heads of the bolt?

Yes, there are studs on the output flange.  On the later ones w/o the
balancer, there are bolts, but you can get to them with the crossmember.
 

------------------------------