[Prev][Next][Index][Thread]

Lets install the BMP/VDO 3 gauge panel part 1 "RESENDING"

Richard says any article over 10,000 characters will bounce and must be
broken up and sent in several parts. I broke up the gauge article into ~ two
equal parts, one and two. For some reason part 1 was abbreviated. Part two
was complete. I will resend part 1 and see what happens. If it is abbreviated
again, I will break up into part 1 and 1a and try again. I apologize for the
confusion, but will figure out how do this.

     Parts used:
                  BMP/VDO gauge panel assembly ~$370.00
                  14 and 16 gauge full mtw or thwn or thnn or gasoline and
oil resistant wire in various colors
                  NAPA Part 784233 Connectors for oil pressure sending unit
$0.94 /package
                  NAPA Part 784234 Connector for ground wire going to left of
dash stud $0.94/package
                  NAPA Part 784217 Connector tap-in 18-14 gauge $0.94/package
                  NAPA Part 784307 Connector insulated female tab for gauge
daisy chain and oil temperature
                  sending unit 16-14 gauge $0.94/package
                  NAPA Part 784295 Connector insulated female tab with male
tab for gauge daisy chain 16-14 
                  gauge $0.94/package
                  NAPA Part 726162 Tie-wraps 4 inch $6.60/package of 100
                  NAPA Part 726129 Tie-wraps 5.5 inch $6.28/package of 25

                  The above is just a reference. MCM 1-800-543-4330 (call for
 a free catalog) and Radio Shack      
                  are other places to look.