Re: [alfa] RE: rear wheel bearings

[Mark Denovich <mark@xxxxxxxxxxxx>]

Gilbert Gagne wrote:
> Once the axle shaft is out the rest of the job requires a hydraulic
> press to remove the old bearing and press on the new one. Check with
> a machine shop. 
To get the old race off, in the past I've used an angle grinder and/or a 
dremel to cut a slice in it... being careful not to cut the axle.   Once 
it's cut you can whack it with a chisel and it will come off.   Crude 
but effective.

--Mark
The Alfa Wiki: http://alfa.denovich.org
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided