Re: 164 clutch throw-out question

["Daegrigg (Don)" <daegrigg@xxxxxxxxxxx>]

Jason,

The car in question is a 91 S.  That may be the procedures for the Q but
according to the manual an my own experience, the bearing will seat "click
in"  by tightening the transmission.

Don

----- Original Message -----
From: Jason <hagen_jason1@domain.elided>
To: Daegrigg (Don) <daegrigg@domain.elided>; Karl Chen <karlcchen@domain.elided>
Cc: <alfa@domain.elided>
Sent: Saturday, August 16, 2003 9:23 AM
Subject: Re: 164 clutch throw-out question


> I just did this job on my 164Q.  Yes, the correct way to do the throw-out
> bearing it to have it on the tranny and marry the tranny up to the engine.
> The bearing will NOT click in when you tighten the bolts.  It will click
in
> by running the motor on the starter and pushing the clutch lever (at the
> transmission) in the opposite direction that pushing on the pedal would.
> The engine has to be running/ rotating for the bearing to snap it.  DO NOT
> try to force it in with the engine not turning.  Be sure to disconnect the
> ECU when doing the starter procedure above, or wait until the job is all
> done and start the engine, then pop in the bearing.
>
> Good luck!
>
> -Jason Hagen
> '73 Spider
> '95 164Q
> ----- Original Message -----
> From: "Daegrigg (Don)" <daegrigg@domain.elided>
> To: "Karl Chen" <karlcchen@domain.elided>
> Cc: <alfa@domain.elided>
> Sent: Friday, August 15, 2003 6:47 PM
> Subject: Re: 164 clutch throw-out question
>
>
> > That is correct.  However, be aware that if you have to remove the TO
> > bearing again, it is very difficult unless you have the special tool.
I
> > would make a dry run with the TO bearing to be sure you have the input
> shaft
> > and clutch disc line up properly.
> >
> > Don
> >
> > ----- Original Message -----
> > From: Karl Chen <karlcchen@domain.elided>
> > To: <alfa-digest@domain.elided>
> > Sent: Friday, August 15, 2003 1:09 PM
> > Subject: 164 clutch throw-out question
> >
> >
> > > When I install the 164S clutch throw-out bearing.
> > > I should hook it on the push rod and let it click
> > > into spring plate by itself when tightening the bolts?
> > >
> > > Karl
> > >
> > > _________________________________________________________________
> > > Help STOP SPAM with the new MSN 8 and get 2 months FREE*
> > > http://join.msn.com/?page=features/junkmail
> > > --
> > > to be removed from alfa, see /bin/digest-subs.cgi
> > > or email "unsubscribe alfa" to majordomo@domain.elided
> > --
> > to be removed from alfa, see /bin/digest-subs.cgi
> > or email "unsubscribe alfa" to majordomo@domain.elided
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided