Re: 164 clutch throw-out question

["Daegrigg (Don)" <daegrigg@xxxxxxxxxxx>]

That is correct.  However, be aware that if you have to remove the TO
bearing again, it is very difficult unless you have the special tool.   I
would make a dry run with the TO bearing to be sure you have the input shaft
and clutch disc line up properly.

Don

----- Original Message -----
From: Karl Chen <karlcchen@domain.elided>
To: <alfa-digest@domain.elided>
Sent: Friday, August 15, 2003 1:09 PM
Subject: 164 clutch throw-out question


> When I install the 164S clutch throw-out bearing.
> I should hook it on the push rod and let it click
> into spring plate by itself when tightening the bolts?
>
> Karl
>
> _________________________________________________________________
> Help STOP SPAM with the new MSN 8 and get 2 months FREE*
> http://join.msn.com/?page=features/junkmail
> --
> to be removed from alfa, see /bin/digest-subs.cgi
> or email "unsubscribe alfa" to majordomo@domain.elided
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided