removing tranny mount

["Ed Prytherch" <dixiedean@domain.elided>]

I replaced the bushing in my tranny using a Sears gear puller and a steel
disc. The disk is 1/4" thick and the diameter is a bit less than the bushing
OD. It has a small hole in the center to match the nipple on the end of the
gear pulIer screw.  I set the gear puller jaws on the far side of the housing
and put a new bushing and the steel disc up against the near side of the old
bushing. I screwed in the puller and pushed the new bushing in and the old
bushing out. I'd do it the same way if I had to do it again.

Ed Prytherch
73 GTV
79 Spider.
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided