re: removing tranny mount

[Dana Loomis <dloomis@domain.elided>]

Ed Prytherch wrote in AD V8 #715

>I replaced the bushing in my tranny using a Sears gear puller and a steel
>disc. The disk is 1/4" thick and the diameter is a bit less than the bushing
>OD. It has a small hole in the center to match the nipple on the end of the
>gear pulIer screw.  I set the gear puller jaws on the far side of the housing
>and put a new bushing and the steel disc up against the near side of the old
>bushing. I screwed in the puller and pushed the new bushing in and the old
>bushing out. 

Brilliant!  
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided