RE: Rear Floor Replacement

[Eppinger Michael R Contr AEDC/SVT <Michael.Eppinger@domain.elided>]

Charlie,
The back of the quarter panels actually bolt to the rear cross member, so
you will not need to support the quarters if you remove the cargo floor.
Actually, the inner quarter panel back by the tail cap is what bolts to the
rear crossmember.  When you remove the floor, depending on how much rot and
rust go suffer from, you may end up removing the middle crossmembers with
the floor.

Hope this helps,

Epp (replacing the inner quarters, outer quarters, and cargo floor and
crossmembers from a terra)

> -----Original Message-----
> From:	Charlie Bierly [SMTP:scoutz@domain.elided]
> Sent:	Thursday, June 24, 1999 7:11 AM
> To:	ihc-digest@domain.elided
> Subject:	Rear Floor Replacement
> 
> Digesters-
> 
> If the crossmembers are left in place, does the rear of the body need to
> be supported when replacing one or both pieces of the rear cargo floor
> (Traveler)? If so, place jack stands under the end cap supports only?
> 
> 
> Charlie Bierly
> 1978 Scout II Traveltop
> 1978 Scout II Traveler