Tranny rebuild ?

[cookiedan@domain.elided (Daniel Nees)]

O.K. guys,
   I have my tranny down and in the basement and I'm pulling it apart. I
have the valve body off and I'll have the rear output housing off
tommorrow night. 
   To remove the pump housing from the case you are supposed to take 2
slide hammers and thread them into two of the holes on the pump and pop
the pump out. 
   So, my question is, since I don't have ONE slide hammer, let alone
two, what can I do to remove the pump housing? I was kinda thinking a
couple pieces of bolt rod with something slid down the rods that I could
use. Any ideas?
   How about 2 'L' shaped rods that I could thread in and hit the 'L'
with a hammer? 

Dan Nees
cookiedan@domain.elided
The
"Good" 1979 Scout II  345/auto 
The
"Bad" 1971 Scout II 304/T-18 
And the
"Ugly" 1979 Scout II 345/auto 

http://members.tripod.com/~IHCaholic/scoutindex.html