[Prev][Next][Index][Thread]

Re: <E30> Armrest

Paul Stehlin <noquilo@domain.elided> writes:
>        BMW sells, or at least used to sell, an armrest w/ a cupholder for
>E30. Have anybody seen how it looks on cars. I've seen it in the Bavarian
>Autosports Catalog, but I can't figure out where it is installed, and
>whether or not the carpet has to be cut a little. If anyone can shed some
>light on the subject I would appreciate a lot.

Yes, I bought one and have it installed in my '90 325iC (E-30).  Personally,
I do not recommend it.  But, it also depends on you and your car.  I'm
6' 4" and drive a stick.  The big problem is that the top of the arm rest
is at the same height as the top of the stick shift knob.  And, since it's
too far forward, I have to raise my elbow to not hit the armrest.  If you're
not as tall (therefore have the seat higher) and drive an auto, it might
not be so bad.

Yes, you need to cut a small bit of carpet from the left (drivers) side 
of the parking brake area to allow a bracket to slip under the mounting
bolt.

When you have a drink in the holder, it interfers with the operation
of the parking brake (when you pull up, it hits the soda!).

Also, this armrest is not made by BMW.  Some company back east in the
USA made it.

          Later... 
            Larry.
______________________________________________________________________________
Lawrence R. Schwarcz, Software Design Engr/NCD      Internet:  lrs@domain.elided
Hewlett Packard Company                               Direct:  (408) 447-2543
19420 Homestead Road MS 43LN                            Main:  (408) 447-2000
Cupertino, CA 95014                                      Fax:  (408) 447-2264
Internal-only WWW: http://hpisrhw.cup.hp.com/~lrs/homepage.html
O-
             Copywight (c) 1996 Elmer Fudd.  All wights wesewved.
______________________________________________________________________________