Re: making a hydraulic press

[Richard Welty <rwelty@xxxxxxxxxxxxxxx>]

On Sat, 31 May 2003 10:21:04 EDT MVICTOR448@domain.elided wrote:

> Does anyone have plans for making a small press; one that could be used
> for 
> pressing wheel bearings, as an example?  Seems to me some angle iron and
> a 
> small hydraulic jack would be the key components.  Thanks!

i don't recall where i got this, but it was probably Classic Motorbooks:

_The Racer's Guide to Fabricating Shop Equipment_, John Block, Steve Smith
Autosports Publications, ISBM 0-936834-45-5

chapter 3 is on how to build a hydraulic press. other chapters cover engine
stands, engine hoists, sheetmetal brakes, and chassis stands.

richard
--
Richard Welty                                         rwelty@domain.elided
Averill Park Networking                                         518-573-7592
              Unix, Linux, IP Network Engineering, Security
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided