hain tightening

[Ferdinando Di Matteo <aroctech@domain.elided>]

1. NO!
2. NO!
3. NO!
4. NO!
Take cam cover off.  Loosen the tensioner bolt NOT MORE THAN ONE full 
turn.  Remove plugs for easier pushing on a slight down hill surface.  
In 5th gear, push the car forward through a couple of revlutions do not 
le he car go backwards even an iota. now notice no slack between cams.  
Tighten the bolt and with he starter motor run it for several seconds.  
Stop, put your hand on the chain half way between cams and press as 
hard as you can.  If it goes slack again a new set of instructions  
will cure the problem.  Fred Di Matteo   AROC USA technical advisor in 
Florida 
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided