Alfa Romeo/Alfa Romeo Digest Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Milano hard starting
- To: alfa@domain.elided
- Subject: Re: Milano hard starting
- From: Antonio Rosciglione <ajr666@domain.elided>
- Date: Wed, 27 Nov 2002 09:24:37 -0500
- Content-transfer-encoding: 7bit
- Content-type: text/plain; charset=us-ascii; format=flowed
- References: <E18H34g-0006Bt-00@domain.elided>
- Reply-to: Antonio Rosciglione <ajr666@domain.elided>
- Sender: owner-alfa@domain.elided
- User-agent: Mozilla/5.0 (Windows; U; Windows NT 5.1; en-US; rv:0.9.4) Gecko/20011128 Netscape6/6.2.1
I think you may have answered or at least pointed yourself in the
direction of the answer when you said the battery is near flat and will
go flat after a few turns of the key. More to the point, you mention
that when you use the race cars battery to jump it, it will start
immediately. Finally, when it does start to run (with its own dying
battery I assume) it runs rough initially.
I would think (no expert here for sure) that if you change the battery
the hard start issue should die. It seems that though you get enough to
crank the engine over, there is just not quite enough juice in the
battery to get the car properly sparked up. The rough idle immediately
after is either due to residual fuel built up in the champers clearing
out or possibley the battery still not up to full charge again.
Seems like a 60 dollar fix to me, or just use the race car battery until
they are on sale.
The battery issue was an issue with a former spyder my brother owned.
Was tough to start and get running. Battery was new but was undersized
(sears screw up). Once the new larger capacity battery was in the car
would fire nearly immediately, this on a Spica car too.
Good luck,
Antonio
----------------------------
Date: Wed, 27 Nov 2002 05:59:10 -0600
From: Steve Wirtz <swirtz@domain.elided>
Subject: Re: Milano hard starting
One of the problems could be the coolant temperature sensor for the fuel
injection. My Spider had a bad one indicating about 120 degrees F even
when cold. Also check the cold start injector and thermo time switch.
Sounds like it is running lean on startup. When the coolant temperature
is lower than 100 degrees F, the injection system is in the cold start
enrichment. As the temperature increases the enrichment decreases.
Steve Wirtz
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided
Home |
Archive |
Main Index |
Thread Index