Milano Drive Shaft Question

["Chris Poore" <caspo@domain.elided>]

I recently bought a Milano Platinum that will be a donor car for my Milano
Gold. I am in the process of changing over the transaxles. After installing
the transaxle from the Platinum, I was re-installing the drive shaft and
found that it was about 1/2" too short. I have checked the length of the two
drive shafts, and they seem to be the same. I installed a new front flex
joint but the width is the same as the original. The only thing that has
changed is the transaxle. Don't have a good way to check the length on the
transaxle. Has anyone run into this kind of problem before?

Thanks
Chris Poore
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided