Shankle Torsion Bars for GTV6 - Help!

["Robert Savi at TechStyle Computers, Inc" <savi@domain.elided>]

I need a sanity check.  When I put the suspension back together, my front end
was about 3" too high.  Rotating the torsion bars per the instructions at the
front and back will require going around more than once.  Logic dictates that
anything more than once around will not work.  Therefore I figured rotating
only the A-arm up one notch would lower it about 2.25".  Problem is now I
can't get the bolts in and clear the A-arm.  I have been putting weight on a
bar to get the A-arm to rotate down, but it won't go down any further without
rotating the whole car!

These are the big 27mm jobs so I have to pull the A-arms off each time I get
it wrong.

Did I rotate the A-arm the wrong way?  Can I go more than a full 360 degrees
on the bars?  Help!

Regards,

Robert C. Savi
Principal/Architect
TechStyle Computers, Inc.

savi@domain.elided
www.techstylecomputers.com      wood computers and electronics
www.gostyle.com                         wood palm pilots and cellular phones
www.woodlogo.com                     wood promotional and gift items
tel  303.629.0966 x11
fax 303.629.0977
fax 303.629.0977
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided