Re:points and condensers

[Lawrence.Gowin@domain.elided]

"- - +12 between coil + and ground
- - coil checks out with resistance check (about 22K between center post and
either terminal, about 9K between terminals)
- - condenser checks out (slowly rising resistance over time)
- - points open and close, and appear to be adjusted more or less correctly
(no dwell meter on hand)
- - distributor turns with engine
- - appears to be a good ground at points"

I don't think you want your points to be grounded.  If you notice when
they're installed, they're insulated from ground.  Check to make sure your
points are grounding out against the distributor. 

Cheers,
Lawrence
'71 GTV - electronic distributor

Lawrence Gowin
Level (3) Communications
lawrence.gowin@domain.elided
Office:	(720) 888-1234

--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided