Bottom end rattle on milano

[Marcantonio Sandro <Sandro.Marcantonio@domain.elided>]

In fact, the bottom end rattle that goes away when the clutch is depressed
is a small bearing in the drivesaft center coupling.  When you press on
the clutch you actually quiet the rattle by decreasing the length of the
driveshaft very very little.

Joel Hailey from centerline gave me this tip. Be careful replacing this
bearing, if you do it wrong your driveshaft will vibrate like a bad
dream.\\\



Sandro Marcantonio
University of Colorado at Boulder
Department of Mechanical Engineering
Fiat Grade-Managment Trainee, Turin (9/00)
1988 Milano Verde
1987 Ducati 750 Paso
1993 Jeep Grand Cherokee Limited
1991 164S (gone, thank god) 

------------------------------