Re: alfa-digest V7 #780 - Fly Wheel Locking Device

[AlfaNeely@domain.elided]

	Mine was made to fit air cooled VW's.  It came from Rex Brown at his 
late lamented Maduko Motori parts store.  I seem to recall the packaging was 
that of a well known off road VW supplier, but I cannot remember the brand.  
It is about three inches long with one hole in the middle and tips on each 
end that fit into the flywheel teeth.  Actually there are four tips, two on 
each side with different spacing to fit different applications.  It takes a 
bit a wiggling to get it set correctly, but holds both four cylinder and 
Milano flywheels quite well.
Ciao,
Russ Neely
Oklahoma City

<< In a message dated 6/4/99 12:29:27 PM Central Daylight Time, 
owner-alfa-digest@domain.elided writes:

<< 
 Date: Fri, 4 Jun 1999 08:19:02 -0700 
 From: Robert Watson <robert.watson@domain.elided>
 Subject: Fly Wheel Locking Tool......
 
 Hi Fellow Digesters.....
  
 I am looking for a US supplier for a Tool that can slip over a stud in the
 rear of the engine block (with transmission removed) to 
 lock the fly wheel in place.  I have seen this tool used on Alfa blocks
 before, but I am unsure of source. Any leads?
 
 Thanks
 
 Robert Watson
 
 67 GTV
 69 Spider 
  >>

------------------------------