RE: Milano clutch, 2nd gear syncro recap

["Brian Shorey" <bshorey@domain.elided>]

> The Milano gear selector shaft has a fitting pressed on to the end and
> held on with a split pin.  Pound long enough on the split pin with a
> correctly sized punch, and it will come out.  Pulling the fitting off
> the selector shaft is another story.  I fabricated a puller that removes
> it easily.  When reinstalling the fitting, heat it up with a propane
> torch and it will slide right on.

nice write up.  one comment on the above - when pounding on that pin, you
should support the shaft from the other side (it's not easy).  paul glynn
has told me of bent shafts when removing stubborn pins without proper
support.

fwiw,

bs

------------------------------