GTV6 suspension upgrades

[Andrew Garcia <aggarcia@xxxxxxxxxx>]

    Here are my .02 cents on GTV6 suspension setup.

        I installed the SZ Dedion bushing in my ITS car two years ago.
The installation is much more difficult than the rubber stock bushing. I
have not had and trouble the the bushing after a season and a half of
road racing and street use. The SZ bushing is real stiff and really
located the Dedion tube. You will notice the the bushing makes a lot of
noise versus the rubber bushing. The SZ unit for track/ high performance
applications in my opinion real helps stiffen the rear of the car.

        I had to install the larger 27 mm front roll bar because the
transition from understeer to oversteer was lightening quick. The larger
bar helped better balance the handling of the car. Instead of the 115
ball joint I went the route of the urethane caster rod bushings from
IAP. The have worked very well and are not any nosier than the stock
bushings. Some may disagree with this, but every setup their car a
little different.

            ANDREWG
            Houston, Tx
            #63 ITS GTV6

------------------------------