Re: V6 Liner O-ring

["Colin Verrilli" <verrilli@xxxxxxxxxxxx>]

JJK1204@domain.elided writes:
> Thanks Colin, Simon,
>
> You both indicate that the liner must be removed. Is there not enough room to
> rotate the engine to put the piston at TDC and then slide the liner almost
> off, clean off the old o-ring and put a new one on?

John,
You'd have to stretch the o-ring to make it fit over the liner (the liner
is notched in where the o-ring fits). If you could do it without snapping
the new o-ring, it might work. In fact, you'd only have to pull up the
liner a half-inch or so (if you can get your hand or a tool down in there
to remove the old one). You also have to be careful about getting gunk
in the area where the liner seats.

Colin.

------------------------------