Re: alfa-digest V7 #27

[Teruhiko_Higashi@xxxxxxxx]

alfa@domain.elided,Internet writes:
>
>Date: Fri, 7 Aug 1998 23:54:37 -0400 (EDT)
>From: connolly@domain.elided (Greg Connolly)
>Subject: Re: HELP - Driveshaft removal problem - GTV-6
>
>Eureka!
>
>Thank you all who responded. 'The screwdriver (in my
>case a Craftsman 12 1/2 " long and with a square
>shaft to rest flat against the egde of the access
>hole) wedged between the donut nuts and a socket
>on a good size breaker bar' solution did the trick.
>I only undid the three nuts holding the driveshaft 
>to the flywheel. I've undone the nuts of the rear
>cover and the hanger bearing support nuts. The whole
>driveshaft slides back but the bottom of the gear-
>shift is in the way so I'll have to remove this and
>I think pry down the rear cover to get the donut 
>through. I'm out of time tonight. Thanks again. 
>
>
>Greg Connolly.
>1973 GTV, Lemans Blue
>1982 GTV-6 Balocco, #173 of 350
> 
If you want to just change the front donut, you could take off the yoke,  slide
the shaft back without the yoke, then turn the yoke with donut on its side and
take it out.  

th

------------------------------