Re: [ihc] Fleck, better late than never, right?

[Joel M Brodsky <jmbrodsky@xxxxxxxxxxxx>]

Well Ryan,
      You are indeed mistaken, the two piece rear axles have a hub flange
that fits on a taper.  If the taper for the Dana whatever
matches what Fleck needs, then he can use these.  I did mis-type the Dana
72 and meant Dana 27.  So, these are for a rear axle, and if
they'll fit a Dana 44 with two piece rear axle shafts, then everything will
work out just fine.

      JoelB


> I have a set of hub outers, 5 on 5.5" from and IH something axle( Dana
72,
> 44?).  You tell me what to measure on the taper and I'll tell you if
these
> are what you want.  I can send you the hubs if you need them, I was going
> to weld them to a swing away and make tire carriers.
>
> Let me know,
>
> Joel
>

Unless I'm misreading, it sounds to me like you're talking about a front
end
wheel hub.

He needs axle shafts for the back.

-Ryan