Re: [ihc] 80 Scout, Koenig PTO Winch Question

[bearbvd@xxxxxxxxxxxxxx (Greg Hermann)]

At 8:50 PM 11/3/03, Ryan Moore wrote:
>----- Original Message -----
>From: "Daniel Nees" <danees@domain.elided>
>To: "Greg Hermann" <bearbvd@domain.elided>
>Cc: "Mac @ TRIAD" <mac@domain.elided>; "Allan Ericson"
><lowvolt@domain.elided>; "John M. Adams" <jma@domain.elided>; <ihc@domain.elided>
>Sent: Monday, November 03, 2003 15:17
>Subject: RE: [ihc] 80 Scout, Koenig PTO Winch Question
>
>
>> Greg,
>>    There is a PTO plate on the BACK of the DANA 20 cases in line with
>> the input of the case.

How in the world can this be--when the rear DRIVESHAFT is in line with the
input of the case ??

Sounds like a Dana 18 from here--

Greg

 I have, in my possetion, a DANA 20 PTO case. I
>> don't have anything to run off of it, but; one of these days I'm going
>> to put it on my Scout, just so there is another stick going up through
>> the floor.    Dennis Petterson and quite a few others have seen this
>> case and have tried to con me out of it. This is NOT Misinformation.
>>
>> Dan Nees
>> danees@domain.elided
>>
>
>Um, you sure you don't have a dana 18?  Since the output for the rear axle
>is in line with the input of the case on a dana 20?
>
>-Ryan