Re: part # needed

[jlandry@domain.elided (John A. Landry)]

As the little green aliens inserted a searing hot probe into the sternum of
Curt Cleavinger <rcleavin@domain.elided>, a blood curdling scream was heard...

>Does anyone happen to have a part # for the seal that goes on the front axle 
>shaft (basically right at the axle u-joint yoke, that goes up against the spindle?
>It's rubber and about 2.5" in diameter. 

For axle code 02013, FA-13

Below chassis number DGD10001, 427806-C91
Chassis number DGD10001 and up, 459301-C1

For axle code 02043, FA-43

459301-C1

For axle code 02044, FA-44

G, CGD chassis numbers, 427806-C91
Chassis numbers DGD, EGD, FGD10001 to FGD23163, 459301-C1
Chassis numbers FGD23163 to KGD10001, 478874-C1
Chassis number KGD10001 and up, 478874-C1

John L.
-------------------------------------------------------------------------- 
jlandry AT halcyon DOT com       | For such a promiscuous conglomeration
Conservative Libertarian         | of numbskulls as generally constitutes
Life Member of the NRA           | an army a six pound pull is well
WA Arms Collectors               | enough.  With an easy pull soldiers
Commercial Helicopter - Inst.    | would decimate their own ranks more
http://www.halcyon.com/jlandry/  | than those of the enemy. T. S. Van Dyke