[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Homemade Roll Cage
> From: "E. Frank Clements" <efrankc@domain.elided>
>
> I have been searching for a place to purchase pre-bent (mandrel bent)
> tubing to make a roll cage for another vehicle of mine. I have found
> kits but they are for full-on racing and not a daily driver.
>
> I could buy a tubing bender and tubing stock but steel in small
> quantities is very expensive. I am hoping to find a place that sells
> the parts that I can use to assemble a cage and customize it and I see
> fit.
Give Kirk a try. They supposedly make quality U-weld cage kits for
a lot of different car models.
http://www.kirkracing.com/
Aside from that, there is always AutoPower, which make both bolt-in
and U-weld (I think...) cage kits.
Regards,
Mike Kohlbrenner
------------------------------