How to reset the service lights

[Evan Arnerich <arnerich@xxxxxxxxxxxxxxx>]

Mike Mike wrote wrote:

> I have a an'88 325...and I am trying to reset the service lights for
an
> oil change.  On the homepage, it states .."run a jumper wire from pin
7
> to pin 19...turn ignition to position 2 and wait until the light goes
> out".  I tried that to no avail.  I noticed that there is no wire
> connected to position #19.  The instructions mention that #19 is
> ground...does that mean connect #7 to ground or what??

Mike,

Pin 7 and 19 are the correct pins. If pin 19 on your car is not
connected (to ground), you may be mis-identifying the pins. You should
be able to connect pin 7 directly to ground, but do make sure that it
really is pin 7. You _really_ don't want to ground the wrong pin.

Hope this helps,
Evan

------------------------------