Refinishing flywheels (was something else)

[alfacybersite <acs@xxxxxxxxxxxxxxxxx>]

Unless one has run the clutch plate down to the rivets, why-oh-why
refinish the flywheel?

Of course it will have a glaze on it. Doubt if it takes long for it to
get that way. I use very coarse sandpaper and break the glaze on the
contact surface before installing the clutch, but other than that...

Now, if one is doing a complete engine rebuild and along with balancing
all the reciprocating components, it is 'a good thing' to have the
flywheel surface milled before balancing - primarily to true it up.

Biba
Irwindale, CA USA
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided