Re: alfa-digest V7 #1328

[bearbvd@domain.elided (Greg Hermann)]

At 9:59 PM 2/6/00, christian147@domain.elided wrote:
>Bradley,
>Try a short arm allen key with the short side cut to 5-7mm.  Really not
>that hard but I use to work next to a tech who always replaced it with a
>hex head.
>
>Good luck
>
>chris hall

The standard tool that Alfa used to provide in the old days was a piece of
flat bar with a very short 14 mm Allen key on one side at one end, and a 17
mm Allen key on the opposite side of the other end. Betcha this tool would
fit in there just fine!

Greg

------------------------------