Replacing spider motor mounts

["Roger F. LaFerriere" <rogerlaf@xxxxxxxx>]

Get a floor jack to support each side of the engine as you remove and =
replace.=20
Three 13mm nuts hold each to the block. One 13mm hex head cap screw =
(upper) and one 13mm nut(lower) are the only fasteners used on the body. =
If the mounts have badly sagged you'll have to use the jack to lift the =
motor enough to get a wrench on the lower nuts. The EFI cars are a pain =
in the ass on the passenger side (LHD) because of the FI.=20
Roger

------------------------------